TM 5-6675-306-14
KEY to fig. 4-6:
1. Plastic tripod head cover 19.
Wooden leg (3)
(b) Inspect the bayonet socket, ring, slide, and
2 Tripod head plate
20. Carrying strap
plumb bob for signs of wear, cracks, or breaks. Inspect
3. Washer
21.
Legholder
the lugs on the bayonet socket for burrs. Inspect the
4. Central fixing screw 22. Clamp jaw
cord for wear.
5. Clamp jaw (2)
23. Screw (3)
6. Nut (3)
24. Legholder (2)
(c) Remove all burrs and replace damaged or
7. Bearing (6)
25. Wedge (3)
defective parts. Use new cord when re- assembling the
8. Leather strap
26. Screw (3)
plumb bob.
9. Screw
27. Bracket (6)
10. Plate clamp (3)
28. Wooden dowel (3)
(3) Reassembly. Refer
to
and
11. Wing screw (3)
29. Wooden leg (3)
12. Clamp band (2)
30. Screw (6)
reassemble the plumb bob.
13. Stop plate (3)
31. Screw (31
14. Screw (6)
32. Stop plate (3)
b. Tripod Wrench.
15. Nut (31
33 Clamp band
16. Shoe (3)
34. Screw (4)
(1) Removal.
Remove the tripod wrench from
17. Washer (3)
35. Bracket (2)
the tripod accessory case (fig. 2-4).
18. Screw (3)
36. Rivet (4)
WARNING
4-21. Plumb Bob and Tripod Wrench
Dry cleaning solvent, P-D-680, used to
a. Plumb Bob.
clean parts is potentially dangerous to
and
personnel and property. Avoid repeated
disassemble the plumb bob.
and prolonged skin contact. Do not use
near open flame or excessive heat.
(2) Cleaning, inspection, and repair.
Flash point of solvent is 100 0 F.-138
F. (38I C. -590C.)
WARNING
Dry cleaning solvent, P-D-680, used to
(2) Cleaning, inspection and repair. Clean the
clean parts is potentially dangerous to
wrench with an approved cleaning solvent and dry
personnel and property. Avoid repeated
thoroughly. Inspect the wrench for wear, burrs, cracks,
and prolonged skin contact. Do not use
or breaks. Remove minor burrs from the wrench.
near open flame or excessive heat.
Check to see whether the wrench engages the bolts on
Flash point of solvent is 100 F. -138'
the tripod head in a satisfactory manner. Replace a
F. (38 0 C.-59 0 C.)
damaged or defective tripod wrench. Stow the wrench
in the tripod accessory case.
(a) Clean all metal parts with an approved cleaning
solvent and dry thoroughly.
4-14
Previous Page
