TM 5-6675-306-14
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTUCTIONS
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
4-1.
Service Upon Receipt of Equipment
Refer to paragraph 2-1 for instructions pertaining to service upon receipt of equipment.
Section II. MOVEMENT TO A NEW WORKSITE
4-2.
Movement to a New Worksite
Refer to paragraphs 2-4 and 2-5 for instructions pertaining to movement to a new worksite.
Section III. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
4-3.
Tools and Equipment
References and illustrations indicating the use of these
tools are listed in the table. The five-digit number
Tools, equipment, and repair parts issued with troop
preceding the stock number is the Federal Supply Code
installed, or authorized for the theodolite are listed in the
Number for the manufacturer of the tool(s). No special
basic issue items list and items troop installed or
equipment is required by organizational maintenance
authorized list, Appendix B.
personnel for performing maintenance on the theodolite.
4-4.
Special Tools and Equipment
The special tools required to perform organizational
maintenance on the theodolite are listed in table 4-1.
Table 4-1. Special Tools
Item
NSN or Part No.
Reference
Use
Figure
Paragraph
Pin, adjusting
(89905)* 6675-00-353-4103
2-5
2-9
Adjust theodolite adjusting screws.
Wrench, tripod
(89905)* 5120-00-378-9520
2-4
2-2
Tripod leg adjustment, removal,
and installation .
4-5.
Maintenance Repair Parts Repair parts and
and special tools list, TM 5-6675-306-24P, covering
organizational maintenance for this equipment.
are listed and equipment. illustrated in the repair parts
Section IV. LUBRICATION INSTRUCTIONS
4-6.
Lubrication Instructions
Refer to paragraphs 3-2 and 3-3 for lubrication instructions.
4-1
Previous Page
