TM 5-6675-270-15
HAND LIGHT AND CABLE ASSEMBLY
Section XXXIV.
tacts. Brush all threaded surfaces free of dirt and
6-133. General
foreign material.
The hand light is used to illuminate the circular
b. Inspection. Inspect the tubes and housings
level and to provide general illumination for night-
for dents, cracks, and breaks. Inspect all insula-
time and dark day operation.
tion for wear and damage. Inspect all contacts for
CAUTION
corrosive damage and breaks. Inspect the
Do not use the hand light in close proxim-
terminals for burs, bends and breaks. Inspect the
ity to the compass.
levers for bends and damage.
c. Repair. Repair minor insulation damage to
6-134. Disassembly
the cable with tape. Straighten out all dents and
Refer to figure 6-15 and disassemble the hand-
bends. Remove all burs. Replace defective parts
light and cable assembly.
that cannot be repaired.
6-136. Assembly
a. Cleaning. Clean all metal parts with a clean-
Refer to figure 6-15 and assemble the hand light
ing solvent. Wipe the cable clean with a soft cloth.
and cable assembly.
Clean the corrosion from the terminals and con-
Previous Page
