TM 5-6675-270-15
REPAIR INSTRUCTIONS
Section I. COMPASS AND COMPASS BRACKET ASSEMBLY
acetone. Clean the window with an approved
glass cleaner. Brush all threaded surfaces free of
The compass, provided with the theodolite, en-
dirt and foreign matter.
ables the operator to rapidly orient the target
b. Inspection. Inspect all threaded surfaces for
with magnetic north.
damage or wear. Inspect the compass base,
housing, and compass legs for bends, breaks,
dents, or burs. Inspect the needle bearing for
a. Remove the compass from the theodolite
excessive wear. Inspect the prism and lens for
cracks, chips, or breaks.
c. Repair. Chase all threaded parts having
pass and compass bracket assembly.
minor thread damage. Smooth out burs. Replace
NOTE
unserviceable parts with serviceable ones.
It will be necessary to use special tool shown in
6-3. Cleaning, Inspection and Repair
pass bracket assembly.
a. Cleaning. Clean all metal parts with a clean-
ing solvent. Clean and polish the prism and lens
b. Install the compass on
the theodolite (para
with lens tissue moistened in grain alcohol or
Section II. TRIBRACH ASSEMBLY
ing solvent. Clean the circular level glass with a
soft cloth or tissue.
The tribrach, leveling screw, and base plate as-
sembly form a leveling base between the bottom
b. Inspection. Inspect all threaded parts for
of the theodolite and the tripod head. The tribrach
worn or damaged threads. Inspect the base plate
contains the circular level, which shows whether
and spring plate for dents, cracks, breaks, and
the tribrach (and therefore, the theodolite itself)
burs. Inspect the tribrach for cracks and breaks.
is level. The leveling screws are mounted in the
Inspect the clamp lever for burs and wear. In-
three mounting lobes of the tribrach, with their
spect the leveling screw components for binding
other ends clamped snugly against the base plate.
or loose fit.
Adjusting one or more of the leveling screws
c. Repair. Remove all burred edges and minor
either up or down will bring the tribrach to a
dents. Chase threaded parts having minor thread
level position.
damage. Replace defective parts that cannot be
repaired.
and disassemble the tribrach assembly.
assemble the tribrach assembly.
6-7. Cleaning, Inspection, and Repair
a. Cleaning. Clean all metal parts with a clean-