INTRODUCTION
Explanation
Code
1. Scope
end item from the supply system.
X1
Applied to repair parts which are not procured or stock-
This manual lists repair parts required for the per-
ed, the requirement for which will be supplied by use
formance of organizational maintenance of the theo-
of the next higher assembly or component.
dolite.
X2
Applied to repair parts which are not stocked. The indi-
cated maintenance category requiring such repair
2. General
parts will attempt to obtain them through cannibali-
zation; if not obtainable through cannibalization, such
a. The Repair Parts List is arranged as follows:
repair parts will be requisitioned with supporting
(1) Individual parts and major assemblies are
justification through normal supply channels.
listed alphabetically by item name within the num-
G
Applied to major assemblies that are procured with
bered functional groups.
PEMA (Procurement Equipment Missiles Army)
funds for initial issue only, to be used as exchange
(2) Assembly components and subassemblies are
assemblies at DSU and GSU maintenance level. These
indented and listed alphabetically by item name
assemblies will not be stocked above DSU and GSU
under major assemblies.
level or returned to depot supply level.
b. This Repair Parts and Special Tools List is
Note. Source code is not shown on common hardware items
divided into the following sections:
known to be readily available in Army supply channels and
(1) Prescribed Load Allowance (PLA) -- Secction
through local procurement.
II. A consolidated listing of repair parts quantita-
(2) Maintenance code indicates the lowest cate-
tively allocated for initial stockage at the organiza-
gory of maintenance authorized to install the listed
tional level. This is a mandatory stockage allowance.
item. The maitenance level code is:
Explanation
(2) Specia l Tools , Test and support Equipment -
Code
Section III. A list of special tools, test and support
O
Organizational maintenance
equipment authorized for the performance of main-
(3) Recoverability code indicates whether unser-
tenance at the organizational level, (Not Applicable).
viceable items should be returned for recovery or
(3) Repair Parts - Section IV. A list of repair
salvage. Items not coded are expendable. Recover-
parts authorized for the performance of mainten-
ability codes are:
ance at the organizational level.
Explanation
Code
(4) Federal Stock Number and Reference Num-
Applied to repair parts (assemblies and components
R
which are considered economically repairable at direct
and general support maintenance levels. When the
bers followed by reference numbers in ascending
maintenance capability to repair these items does not
alpha-numeric sequence, cross-referenced to index
exist, they are normally disposed of at the GS level.
number,
When supply considerations dictate, some of these
repair parts may be listed for automatic return to
supply for depot level repair as set forth in AR 710-
50, When so listed, they will be replaced by supply on
The following provides an explanation of columns in
an exchange basis.
the tabular lists in Sections II, III, and IV;
Applied to high dollar value recoverable repair parts
T
a. Source, Maintenance and Recoverability Codes
which are subject to special handling and are issued
(SMR).
on an exchange basis. Such repair parts are normally
(1) Source code indicates the selection status and
repaired or overhauled at depot maintenance
activities.
source for the listed item. Source codes are:
U
Applied to repair parts specifically selected for salvage
Eplanation
Code
by reclamation units because of precious metal con-
Applied to repair parts which are stocked in or supplied
P
tent, critical materials, or high dollar value reusable
from DSA/GSA or Army supply system, and autho-
casings or castings.
rized for use at indicated maintenance categories.
(4) This
column also lists, below the SMR code,
Applied to repair parts which are not procured or stock-
M
ed but are to be manufactured at indicated mainten-
an index number for each item in ascending numeri-
ance categories.
cal sequence, which is used to locate items in the
A
Applied to assemblies which are not procured or stocked
publication when the Federal stock number and/or
as such, but are made up of two or more units, each
reference number is known.
of which carry individual stock numbers and de-
b. Federal Stock Number. This column indicates
scriptions and are procured and stocked separately
and can be assembled by units at indicated mainten-
the Federal stock number for the item.
ance categories.
c. Description. This column indicates the Federal
Applied to parts and assemblies which are not procured
X
item name and any additional description of the item
or stocked, the mortality of which is normally below
required. A part number or other reference number
that of the applicabl end item or component, and
the failure of which should result in retirement of the
iii
Previous Page
