TB 55-1520-238-20-24
9.
Special Tools, Jigs and Fixtures Required.
NSN
PART NO
NOMENCLATURE
Basic Crimping Tool
5120-00-133-1747
M22520-7-01
Positioner
5120-01-122-1201
M22520/7-11
5120-00-132-6328
Installation/Removing Tool
M81969/16-01
Basic Crimping Tool
5120-00-132-6913
M22520/5-01
Die
5120-00-126-0860
M22520/5-100
M83507/14-01
Compressed Air/N2 Heat Gun
10.
Inspection Procedures.
Remove access panel R578.
a.
b. If wire harness W154 has heat shrink sleeving installed
on the tail light wires (L9D22 and L5H22), no further action is
required. Reinstall access panel R578.
c. If wire harness W154 does not have shrink sleeving
installed on the tail light wires (L9D22 and L5H22), reinstall
access panel R578 and enter on DA Form 2408-13 that the
corrective requirements of this Technical Bulletin will be
accomplished during the next phase inspection. During the phase
inspection accomplish the corrective procedures contained in
11.
Correction Procedures.
Remove the vertical stabilizer tip assembly
(7-311122600-7) (TM 55-1520-238-23).
b. Remove wires L9D22 and L5H22 from the navigation tail
light (XDS7). Cut string ties and remove clamps securing wires
along distance of wires from lug to splice.
c. Install MS25036-102 terminal on one end of each 24 inch
length of M22759/34-20-9 (MIL-W-22759/34) electrical wire (TM
55-1500-323-24) .
d.
Cut 4 lengths of MS23053/5-104-9, each 1.5 inches
long. Slip 1 piece of sleeving over each new wire adjacent to
lug (Fig. 1) Shrink sleeving in place (TM 55-1500-323-24).
e. Slip another length of MS23053/5-104-9 over wire and
newly applied sleeve, adjacent to lug. Shrink sleeving in place
(TM 55-1500-323-24). This will form 2 layers of shrink sleeve
butting up next to lug (Fig. 1).
3
--
Previous Page
