TM 55-1905-223-24-14
b. Column 2, Component/Assembly. Column 2 contains the noun names of components, assemblies,
subassemblies, and modules for which maintenance is authorized.
c. Column 3, Maintenance Function. Column 3 lists the functions to be performed on the item listed in Column 2.
(For detailed explanation of these functions, see paragraph B-2.)
d. Column 4, Maintenance Category. Column 4 specifies, by the listing of a work time figure in the appropriate
subcolumn(s), the category of maintenance authorized to perform the function listed in Column 3. This figure represents
the active time required to perform that maintenance function at the indicated category of maintenance. If the number or
complexity of the tasks within the listed maintenance function vary at different maintenance categories, appropriate work
time figures will be shown for each category. The work time figure represents the average time required to restore an
item (assembly, subassembly, component, module, end item or system) to a serviceable condition under typical field
operating conditions. This time includes preparation time (including any necessary disassembly/assembly time),
troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to perform
the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol
designations for the various maintenance categories are as follows:
UNIT
C - Operator or Crew
O - Organizational Maintenance
INTERMEDIATE
F - Direct Support Maintenance
H - General Support Maintenance
DEPOT
D - Depot
e. Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools) and
special tools, TMDE, and support equipment required to perform the designated function.
f. Column 6, Remarks. This column shall, when applicable, contain a letter code, in alphabetic order, which shall be
keyed to the remarks contained in Section IV.
B-4. Explanation of Columns in Tool and Test Equipment Requirements, Section III.
a. Column 1, Reference Code. The tool and test equipment reference code correlates with a code used in the MAC,
Section II, Column 5.
b. Column 2, Maintenance Category. The lowest category of maintenance authorized to use the tool or test
equipment.
c. Column 3, Nomenclature. Name or identification of the tool or test equipment.
d. Column 4, National Stock Number. The National stock number of the tool or test equipment.
B-3
Previous Page
