TM 5-6675-312-14
4-17. ADJUSTING PINS AND SCREWDRIVER - MAINTENANCE INSTRUCTIONS (CONT)
This task covers:
a. Pre-Inspection
b. Removal
c. Cleaning.
c. Disassembly
e. Inspection
g. Installation
INITIAL SETUP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1. Accessory case
Adjusting
Remove from accessory
Refer to figure
pins and
case.
screwdriver
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive
heat. Flash point of solvent is 100 . 138 . (38 . 59 . ) Do not use P-D-680 to clean lens.
F
F
C
C
2. Accessory case
Adjusting
a. Clean with cleaning
pins and
solvent and dry
screwdriver
thoroughly.
b. Inspect for nicks,
burns, and
corrosion.
c. Remove nicks, burrs
and corrosion.
d. Replace de-
fective parts.
INSTALLATION
3. Accessory case
Adjusting
Install adjusting
Refer to figure
pins and
pins and screw-
screwdriver
driver in
accessory case.
4-21
Previous Page
