ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
D
Depot
b. Column 2: Component/Assembly. Column 2
lists the noun names of components, assemblies, subas-
e. Column 5: Tools and Equipment. Column 5
semblies, and modules for which maintenance is autho-
specifies by code, those common tool sets (not individ-
rized.
ual tools) and special tools, test, and support equipment
required to perform the designated function.
c. Column 3: Maintenance Functions. Column 3
lists the functions to be performed on the items listed in
f. Column 6: Remarks. Column 6 contains an
column 2.
alphabetic code referring to Section IV, Remarks,
which is pertinent to the item opposite the particular
d. Column 4: Maintenance Category. Column 4
code.
specifies, by listing of a work-time figure in the appro-
priate column(s), the lowest level of maintenance autho-
D-4. Took and Test Equipment Requirements, Section
rized to perform the function listed in column 3. This
III.
figure represents the active time required to perform
a. Column 1: Reference Code. The numbers in
that maintenance function at the indicated category of
this column coincide with the numbers used in the tools
maintenance. If the number of complexity of the tasks
and equipment column of the Maintenance Allocation
within the listed maintenance function vary at different
Chart.
maintenance categories, appropriate work-time figures
will be shown for each category. The number of man-
b. Column 2: Maintenance Category. The codes in
hours specified by the work-time figure represents the
this column indicate the maintenance categories allo-
average time required to restore an item (assembly,
cated.
subassembly, component, module, end item, or system)
c. Column 3: Nomenclature. This column lists
to a serviceable condition under typical field operating
tools, tests, and maintenance equipment required to
conditions. Subcolumns of the maintenance category
perform the maintenance functions.
are as follows:
d. Column 4: National/NATO Stock Number.
C
Operator/Crew
This column lists the National/NATO Stock Number
of the specific tool or test equipment.
O
Organizational
e. Column 5: Tool Number. This column lists
F
Direct Support
manufacturing part number and Federal Supply Code
H
General Support
for Manufacturers (FSCM).
D-2
Previous Page
