TM 5-6675-306-14
STEP 1.
REFER TO PARAGRAPH 2-2 AND SET UP THE
THEODOLITE.
STEP 2.
OBSERVE STATION POINT THROUGH OPTICAL
PLUMMET EYEPIECE. IF STATION POINT IS NOT
CENTERED IN THE EYEPIECE CIRCULAR MARKS,
USE ADJUSTING PIN (FIG. 2-5) TO TURN THE
TWO HORIZONTAL ADJUSTING SCREWS FOR
LATERAL
ALIGNMENT.
FOR
VERTICAL
ALIGNMENT, LOOSEN CHECK NUT AND TURN
VERTICAL ADJUSTING SCREW.
STEP 3.
WHEN THE STATION POINT IS CENTERED IN THE
EYEPIECE CIRCULAR MARKS, TIGHTEN THE
CHECK NUT.
Figure 2-22. Optical plummet, adjustment.
2-10. Operation of Theodolite
c. Install the diagonal eyepieces as necessary
a. Set up the theodolite on the tripod (para 2-
2).
d. Install the telescope eyepiece black sunglass
e. Perform the daily preventive maintenance
NOTE
rheostat knob until desired brilliance is obtained.
Place the hand light switch in the ON position.
2-33