TM5-6675-296-14
support equipment r e q u i r e d to perform the
appropriate subcolumn(s), the lowest level of
designated function.
maintenance authorized to perform the function
f. Column (6), Remarks. This column contains a
listed in column (3). This figure represents the
letter code in alphabetic order which is keyed to
active time required to perform the maintenance
the remarks contained in Section IV.
function at the indicated level of maintenance. If
the number or complexity of the tasks within the
D-4. Column Entries Used in Tool and Test
l i s t e d maintenance function vary at different
Equipment Requirements
maintenance levels, appropriate work time figures
a. Column ( 1 ) , T o o l o r T e s t E q u i p m e n t
will be shown for each level. The number of man-
Reference Code. The tool and test equipment
hours specified by the work time figure represents
reference code correlates with a maintenance
the average time required to restore an item
function on the identified end item or component.
(assembly, subassembly, component, module, end
b. Column (2), Maintenance Level. The lowest
item, or system) to a serviceable condition under
level of maintenance authorized to use the tool or
typical field operating conditions. This item in-
test equipment.
cludes preparation time, troubleshooting time, and
c. Column (3), Nomenclature. Name or iden-
quality assurance/quality control time in addition
tification of the tool or test equipment.
to the time required to perform the specific tasks
d. Column (4), National/NATO Stock Num-
identified for the maintenance functions authorized
ber. The National or NATO stock number of the
in the maintenance allocation chart. The symbol
tool or test equipment.
designations for the various maintenance levels are
--
e. Column (5), Tool Number. The manufac-
as follows:
ture's part number.
C . . . . . . . . . . . . . . . . . . Operator or crew.
O . . . . . . . . . . . . . . . . . . . Organization maintenance.
D-5. Explanation of Columns in Section IV
F . . . . . . . . . . . . . . . . . . . Direct support maintenance.
a. Reference Code. The code scheme recorded in
General support maintenance.
H
column (6), Section II.
D . . . . . . . . . . . . . . . . . . . Depot maintenance.
b. Remarks. This c o l u m n lists information
e. Column (5), Tools and Equipment. Column
p e r t i n e n t to the maintenance function being
(5) specifies, by code, those common tool sets (not
performed as indicated on the MAC, Section II.
i n d i v i d u a l tools) and special tools, test, and
Previous Page
