C 3, TM 9-1290-335-35
Section V. OVERHAUL OF HOUSING
ASSEMBLY 10954711 AND RELATED PARTS
Note
Note
All gear teeth to be coated with
Prior to disassembly, scribe a
grease MIL-G-10924 at assernbly or
reference mark on collar (2, fig. 6-8)
installation.
and shaft (6).
a.
Install bearing (13, fig. 5-8) in housing (14).
5-22. Disassembly
of
Housing
Assembly,
Insert key of locking plate (11) in keyway of bearing (13)
10954711 and Related Parts
and rotate counterclockwise until tight against housing.
a.
Drive out pin (1) and remove item 2 through
b.
Install items 12 through 10.
6.
c.
Assemble items 7 through 9 and insert item
b.
Disassemble items 7 through 9.
6 in item (14).
c.
Remove items 10 and 11.
d.
Insert one spring (4) end in 1/8 diameter
d.
Drive out pin 12.
hole in gear (3). Place gear (3) with spring (4) in gear
e.
Insert key of locking plate (11) in keyway of
(5) compressing spring and rotating clockwise until the
bearing (13) and rotate clockwise until free from housing
other spring end drops into 1/8-diameter hole in gear (5).
(14).
Hold gear (3), spring (4) and gear (5) together and install
on shaft of item 6 with collar (2) and pin (1).
5-23. Assembly of Housing Assembly 10954711
and Related Parts
Section VI. INSTALLATION OF MAIN ASSEMBLIES
installation of housing assembly 7537556 and related
5-24. Installation
parts to housing assembly 10954711, with related parts,
For installation of housing assembly 10954711 and
related parts to housing assembly 10954707, with
Section VII. FINAL TEST AND ADJUSTMENT
b.
To eliminate backlash (without binding)
5-25. Backlash Test Adjustment
lossen setscrew (10, fig. 5-6) and rotate stud (11) to
a.
Setup and test azimuth indicator 10954720
establish 0.5 mil tolerance.
5-10/(Page 5-11 blank)