TM5-6675-296-14
TS 6675-296-14/4-20
(3) Cleaning, Inspection, and Repair.
(a) Clean all metal parts with soap and
water and dry thoroughly.
(b) Clean the carrying strap with saddle
soap.
(c) Inspect the strap for cracks, breaks, and
c u t s . Inspect for worn mounting holes and
(d) Inspect the lever pins for burrs and
wear. Inspect the locking levers and lever clamps
for burrs, bends, and cracks. Inspect for enlarged
1. CARRYING STRAP
mounting holes.
2. CLAMPING LEVER (2)
(e) Inspect the hood for dents, cracks, and
3. HOOD
holes. Inspect the bottom rim for out-of-round.
4. BASE
(f) Remove all burrs from the lever pins,
TS 6675-296-14/4-19
locking levers, and lever clamps. Straighten minor
dents. Remove all traces of rust and repaint where
necessary.
(g) Straighten minor dents or bends in the
installation.
hood. Seal all cuts or holes in the hood. Repaint
where necessary.
(2) Disassembly.
(h) Replace all defective parts that cannot
be repaired.
(2) from levers (3).
(4) Assembly.
(b) Remove rivets (4) and washers (5) from
carrying strap (6).
levers (3) with rivets (4) and washere (5).