TM5-1260-206-34
APPS System Fine Alignment Procedures - Continued
Table 2-10.
STEP ITEM
NO.
PROCEDURE
11
System zero
Zero alignment meter (15) by doing the following:
a.
Loosen locking screw (l).
1.
2.
Rotate dial (2) to indicate
zero.
Tighten locking screw.
3.
Press:
b.
Fine Alignment
12
NOTE
When moving photo-carriage with adjust
screw, always approach desired meter or
direction. If desired indication is
overshot, back up past it and continue.
Do the following procedure:
X Display
Rotate adjust
indication
Observe
Adjust
screw (14)
Changes from 0.124 to
R40
Clockwise
a.
0.125
Alignment Meter
Counter-
b.
High-to-low
clockwise
transition on
center grid
line
Zero system - (See step 11.)
c.
Repeat steps a. through c. until no further adjustment is
d.
needed.
2-38