TM 32-5865-010-24&P
(6) Replace top and bottom covers (1) in accordance with
f. Identification Plate Removal and Replacement. To remove
identification plate (22) from side panel, proceed as follows:
(1) Remove top access cover (1) in accordance with paragraph
(2) Remove identification plate by removing two screws (23),
four flat washers (20), two lock washers (25), and nuts
(24) securing plate to side panel (21) .
(3) Attach replacement identification plate (22) to side panel
(21) by alining mounting on plate with those on side panel
and securing with two screws (23), four flat washers (20),
two lock washers (25), and nuts (24).
(4) Replace top access cover in accordance with paragraph
Repair.
Repair instructions for the DF control-indicator consist of
replacing defective switch/indicators, and performing rivet and
fastener repair.
To replace a switch/
a. Switch/Indicator Removal and Replacement.
indicator, proceed as follows:
(1) Remove front panel as required to gain access to the rear
(2) To remove the indicator portion of the switch/indicator
NOTE
The switch/indicator assemblies are equipped with
a retaining strap that allows the indicator portion
to hang free from the switch assembly without
becoming separated.
(3) Using a screwdriver, loosen the two locking cam adjustment
screws until the two locking cams are free.
(4) Slide the switch assembly forward to gain access to the
switch wiring.
(5) Using contact removal tool MS-27534-20 (MK-1961/G) , remove
and tag each wire from the defective switch and remove
switch assembly with associated mounting and retaining
sleeves.