TM 32-5865-010-24&P
(4) To replace either connector J1 or J2, insert wires into
connector as tagged during removal using appropriate
insertion tool.
(5) Attach connector J1 (6) and/or J2 (7) to rear panel with
four screws (8), washers (9), lock washers (10), and nuts
(11).
d. Front Panel Removal and Replacement. The front panel cannot
be removed from the unit without removing all eight switch/indicators
or their respective wiring.
The front panel may be detached from the
unit as follows:
(1) Remove six nuts (12), lock washers (13), and flat washers
(14) securing the front panel (15) to the side plates (16).
(2) Remove eight switch/indicators in accordance with paragraph
5-11a, steps (2) through (5) .
(3) Detach the front panel from the unit.
(4) To replace front panel, replace eight switch/indicators in
(5) Aline the six clinch studs (17) on front panel with six
mounting holes on the side plates (16) , and secure with six
flat washers (14), six lock washers (13) and nuts (12).
Left and Right Side Panel Removal and Replacement. To remove
e.
left or right side panel (16) from the unit, proceed as follows:
(1) Remove top and bottom covers (1) in accordance with
(2) Remove three screws and washers (4 and 5) that secure rear
panel (3) to side panel.
(3) Remove three nuts (12), lock washers (13) and flat washers
(14) that secure side panel to front panel (15).
(4) When removing the right side panel (16), remove iden-
tification plate (18) by removing two screws (19), four
flat washers (20), two lock washers (21) and nuts (22) that
secure the plate to the side panel.
(5) To replace side panel, aline three clinch studs (17) on
front panel through mounting holes on side panel and secure
with three flat washers (14) , lock washers (13) and nuts
(12). When replacing right side panel (16) , secure iden-
tification plate (18) to panel with two screws (19), four
flat washers (20), two lock washers (21) and nuts (22).